MODEL 430

STRUCK LEVEL 275 CU. FT., 430 BU. UNLOADING SPEED FOR THE 430 SPREADER - (2 SPEED CHAIN DRIVE) HIGH SPEED: PTO SPEED 540 RPM. 8 FT 8 1/2 IN PER MIN. - LOW SPEED: PTO SPEED 540 RPM. 4FT 8 1/2 IN PER MIN. FRONT SPLASH GUARD IS STANDARD EQUIPMENT. 

OPTIONAL REAR PAN

OPTIONAL REAR PAN IS AVAILABLE ON THE MODEL 430.    

MASSIVE UNITIZED WELDED FRAME

H&S SPREADERS HAVE A MASSIVE UNITIZED WELDED FRAME WITH HEAVY FLOOR SUPPORTS AND SIDE STAKES, WRAP AROUND STEEL FRONT CORNERS. STRONG REAR MAIN BEATER SIDE PANELS ARE SLANTED FOR CLEARANCE AND WIDER SPREAD, AND THEN WELDED TO THE STRONG 5'' U CHANNEL SIDE MEMBERS. COMPARE WITH ANY ON THE MARKET.

REINFORCED PLYWOOD

SIDES, FRONTPANEL AND BOTH SIDES OF THE REAR HYDRAULIC END GATE USE FIBERGLASS REINFORCED PLYWOOD TO PROVIDE FOR EASY CLEANING AND MINIMAL FREEZE UP. THE 430 HAS A SOLID VIRGIN GRADE POLY FLOOR. CONSIDERABLY LESS TORQUE IS NEEDED TO MOVE A HEAVY LOAD.

OPTIONAL TOP BEATER

MODEL 430 CAN BE EQUIPPED WITH THE OPTIONAL TOP BEATER TO PROVIDE LOAD LEVELING AND SPREADING OF HIGH HEAPED LOADS. NOTICE HOW BOTH BEATERS HAVE NO OBSTRUCTIONS TOWARDS THE SIDES AND REAR TO PROVIDE FOR BETTER SPREADING.

 2-SPEED APRON DRIVE

THE 2-SPEED APRON DRIVE IS STANDRAD EQUIPMENT. AN OPTIONAL VARIABLE SPEED HYDRAULIC DRIVE IS ALSO AVAILABLE.

SEMI-LIQUID HYDRAULIC ENDGATE

A SEMI-LIQUID HYDRAULIC END GATE IS STANDARD EQUIPMENT. A SECOND HYDRAULIC ENDGATE CYLINDER IS STANDARD.

29'' DIAMETER BEATER

THE MODEL 430 SPREADER HAS A 29'' DIAMETER BEATER WITH 14 REPLACABLE PADDLES. THE BEATER HAS TWO TYPES OF PADDLES, BLUNT FOR WIDESPREAD AND SHARP RIPPER TYPE FOR CUTTING AND SHREDDING. THE BEATER SIDE WIPER BLADES ARE STANDARD.

OIL BATH BEVEL GEAR BOX

THE STRONG OIL BATH BEVEL GEAR BOX THAT POWERS THE BEATER IS TAPERED TIMKEN ROLLER BEARING EQUIPPED. ALSO SHOWN IS THE REPLACEABLE SPLINED HUB THAT WELDS INTO THE MAIN BEATER TUBE. THE GEAR BOX UTILIZES A 4-JAW BEATER SHUTOFF CLUTCH AND TRACTOR SIZED SPLINE SHAFT.

TIMKEN TAPERED ROLLER BEARING EQUIPPED

GEAR BOX MECHANISMS AND DRIVE FOR THE BEATER AND APRON ARE TIMKEN TAPERED ROLLER BEARING EQUIPPED. THE BEATER DRIVE GEAR BOX IS 1-1 1/2 BEVEL GEAR OIL BATH EQUIPPED WITH A 4-JAW OVER RUNNING CLUTCH FOR BEATER SHUTOFF. THE APRON DRIVE IS A 50:1 BRONZE WORM GEAR WITH SHEAR BOLT PROTECTION. 

EASY APRON ADJUSTMENT

ADJUSTMENT FOR THE MAIN APRON IS EASY, BY SIMPLY LOOSENING THE TWO SIDE BOLTS AND DRAWING UP THE LONG BOLT.

STEEL ALLOY APRON IDLER

H&S USES CAST SPECIAL STEEL ALLOY APRON IDLER SLIDES INSTEAD OF IDLER SPROCKETS MAKING FOR YEARS OF DEPENDABLE SERVICE.

VARIABLE HYDRAULIC DRIVE

AN OPTIONAL VARIABLE SPEED HYDRAULIC DRIVE IS ALSO AVAILABLE.