|
88” Cutting width |
A good cutting width for many applications. |
|
3-Point screw type hitch can be offset 7 3/4” Left & right |
Easily offset the hitch for a closer cut alongside buildings, fences, roadsides and for getting under tree limbs. |
|
ACME threads on offset |
ACME threads are deeper allowing for easy screwing adjustment. |
|
One year gearbox warranty
|
The gearbox is designed tough to withstand the rigors of flail mowing. |
|
540 RPM cast iron gearbox with over-running clutch |
Enables the rotor to free swing to a stop when the tractor PTO has been turned off. |
|
1/2” – 6” Cutting height |
Variable cutting heights for many uses. Lowest cutting height allows for scalping in grasses such as Bermuda prior to overseeding. |
|
2” Cutting capacity |
Cut saplings when used in a rough setting. |
|
Forged hammer knives |
Forged hammers are just right for chopping up prunings up to 2" thick, but will also groom grass in a very acceptable manner. |
|
5 1/2” Rotor diameter |
Large rotor is able to take rough conditions. |
|
Reverse rotor rotation |
Brings the cut material up and over which allows it to be dispersed more evenly. |
|
High knife tip speed |
Knife tip speed of 9,805 fpm for cleaner cut. |
|
Cat. 4 driveline |
Heavy-duty driveline matches up with HP range as well as potential conditions. |
|
4 - 'B' Section belts |
'B' Section belts have more surface to pulley contact and fits deeper in the groove. |
|
3/16” Deck thickness |
Allows the mower to handle rough conditions. |
|
Baffles on top inside of deck |
Keeps cut material from clumping together, ensuring an even distribution of clippings. |
|
Height adjusting roller |
Rear height adjusting roller with greaseable bearings and tapered ends to prevent gouging during turns. |
|
Standard scrapers on rear height adjusting roller |
Keeps roller clean for consistent cutting height. |
|
Hinged rear gate |
Can be opened for easier discharge in heavy conditions, or left closed for greater mulching capabilities. |
